Page 1
Compact Flash Hardware Installation 1 Introduction 2 Tools Required This Information Sheet describes the procedure for fitting • Medium, flat-bladed screwdriver Compact Flash hardware to SM2000 instruments. • No. 1 Pozidriv screwdriver 3 Fitting Media Board , GR2000/0700, Compact Flash Media Service Pack includes the following items: Sub-Assembly –...
Page 2
…3 Fitting Media Board Sub-Assembly – Figs. 3.1 to 3.5 3) Remove the chassis top cover and PCB locking bar – see Fig. 3.2. Lift up top cover Remove pozidriv screws Remove top cover (one each side) Remove PCB locking bar Fig.
Page 3
…3 Fitting Media Board Sub-Assembly – Figs. 3.1 to 3.5 5) Check the position of PCB link LK1 – see Fig. 3.4. 3.3V Position Compact Flash Check that PCB link LK1 5V Position is fitted and is in the SmartMedia correct position for Compact Flash hardware.