Advertisement
HUAI
This unit can be operated with the following power sources.
e An NP-1 or NP-1A rechargeable battery pack
¢ A BP-90 or BP-90A rechargeable battery pack
e AC power source with an AC-500CE/500 AC power adaptor
Rechargeabie battery pack—NP-i
or NP-iA
A fully-charged battery provides approximately 50 minutes of continuous operation
with a BVP-5P video camera.
Charging
Before operating, always charge the battery pack using the BC-1WACE battery
charger. The charging period is approximately 1 hour at normal temperatures.
For details on charging, read the instruction manual of the BC-1WACE.
Battery installation
1 Open the battery case cover.
=
Push up.
2 Insert a battery pack.
|
NP-1 or NP-1A
\
_/
Notes on battery
« When the battery pack is installed, the power is always
* The battery pack may not charge if you try to rechargeit
supplied to the time code circuit even if the POWER
immediatery after it has been used. If this happens, wait
switch is set to OFF. Remove the battery pack from the
for a few minutes before recharging it.
battery compartment when the unit will not be used for
along period of time.
To install two battery packs simultaneously
Use the DC-520 battery adaptor. It is useful for a long tine
use.
20 (E)
Advertisement
