Advertisement
ITU
To check the last scene of the previous recording (recording review)
Press the RET button on the lens after recording.
The last two seconds of the recorded scene are played back and then the unit will
enter the standby mode.
When the RET button is kept pressed, the last recorded picture can be seen for a
maximum
10 seconds.
Recording review is possible only when the recording is longer than one second.
Frame-accurate backspace editing
As long as the cassette is not ejected, frame-accurate backspace editing can be made
when the CAMERA/VTR switch on the camera is set to the VTR STBY.
Even if the CAMERA/VTR
switch is in the VTR SAVE position, the unit will go into the
frame-accurate backspace editing by simply pressing the VTR or VTR START button.
In this case, however, it takes a little longer to start recording (approx. 3 seconds).
To start frame-accurate backspace editing after the power has been turned off or the
cassette has been ejected, or to record on a previously recorded tape, proceed with
the following steps.
1 Find the point you want to start editing by monitoring the viewfinder screen, and
stop the tape.
2 Press the RET button on the lens.
The starting point will be searched for.
3 Press the VTR or VTR START button.
Editing will begin.
44 (E)
Advertisement
