Advertisement
iii
Checking the VTR
Proceed with [A] through [E] continuously.
[A] Check the tape transport
1 Set the F-RUN/R-RUN switch to R-RUN.
2 Set the DISPLAY switch to CTL.
3 Press the VTR START button of the camera.
Check that:
¢ The reel inside the cassette rotates.
¢ The figures on the display change as the tape runs.
¢ The REC lamp in the viewfinder lights.
¢ The RF and SERVO indicators on the display do not light up.
y
4 Press the VTR START button again.
Check that the tape stops and the REC lamp in the viewfinder goes off.
1
5 Press the VTR button on the lens.
Check that:
¢ The reel inside the cassette rotates.
¢ The figures on the display change as the tape runs.
¢ The REC lamp in the viewfinder lights.
¢ The RF and SERVO indicators on the display do not light up.
V
6 Press the VTR button again.
Check that the tape stops and the REC lamp in the viewfinder goes off.
Y
7 Press the RESET button.
Check that the figure on the display is reset to ''00:00:00:00".
1
8 Set the LIGHT switch to ON.
Check that the display window and the level meters are illuminated.
34 (E)
Advertisement
