Table of Contents
Advertisement
!
Caution
2. Ambient humidity of 85% or less during operation.
3. Other conditions for storage and operation
a) Level floor of sufficient strength
b) No condensation
c)
Dust-free environment
d) Well ventilated
e) Environment free of corrosive or explosive gas
f)
Not subject to direct sunlight
g) No danger of fire
h) Do not exceed the maximum ambient temperature of the
temperature range of product specification at the time of
pump installation. (refer to table1-1)
(3) Attach a vent and a fan for cooling in a device to lower pump use atmosphere temperature.
In addition, please do not block up the vent of the pump cooling fan.
Leave the space more than 100mm than the pump appearance.
Operation
(4) Touching rotating components (eg motor, main shaft, axial joints, cooling fan) while the pump
is in operation may result in injury.
(5) When the thermal protector operates, the pump will become extremely hot. Please do not
touch the pump. Touching the pump in that condition will cause burn injury. Turning off the
main power supply of the system, please contact us.
(6) Touching the motor while the pump is in operation or while it is still hot immediately after
having been switched off may result in burns.
(7) Inserting fingers or objects, or peering, into, the inlet or outlet during operation may result in
injury or malfunction.
Maintenance and Repair
(8) If the pump ceases operation, switch off the main power supply immediately to prevent
accidents, remove the power cord from the power supply, and contact your dealer or the
manufacturer for inspection and repair.
(9)After stopping the pump, leave it for 30 minutes or more and begin work on it only after
checking that it has cooled sufficiently. The interior of the pump is extremely hot immediately
after it has been switched OFF, and burns may result if it is touched in this condition.
０６
Advertisement
Table of Contents
