Hisense AMW2-18U4RJC Technical & Service Manual page 96

10. FIELD SETTING
E-Series wired controller
1) Connecting wired controller with the indoor unit
Step 1: Remove the upper cover of the wired controller
NOTE:
Control board of the remote controller is placed on upper
cover. Please protect it from being scratched during removal
and installation!
Step 2: Connect the wired controller with the indoor unit
Indoor unit control board
2) Changing system parameter
root address sub-address
OPERATION：
1. Press and hold the "
state, Then the "
2. Press the " " / "
3. Press the " " / "
sub-address value.
4. Press the " "/ "
5. Press the " " button to exit without settings.
Parameters value code
" and "
" button for 3s at the same time to enter the parameter self-setting
" and " " icon will be always on.
" button to increase or decrease the root address as 3.
" button to increase or decrease the sub-address, and select the desired
" button to set parameters,and press "
Marked with: wired
root address+ sub-address+
3
root address- sub-address-
90
Upper cover of the wired controller
Lower cover of the
wired controller
Insert the slotted screwdriver in the slots,
and rotate gently to remove the upper
cover.
Connection cord of wired
controller (to indoor unit)
Wired remote controller
1
4
" button to confirm.