Connection To The Power Supply - AGA eR7 Series User's Manual & Installation Instructions

Hide thumbs Also See for eR7 Series:
Table of Contents

Advertisement

29. Connection to the Power Supply

This range must be supplied with a 240V, 60Hz power
supply and connected to an individual, properly grounded
branch circuit protected by a circuit breaker. At 240V, it has a
maximum load of 30 amps. Electric hook-up must be done by
a licensed electrician. This unit must be installed according
to regional codes, or in the absence of codes, the National
Electrical Code.
• Product installation requires a separate (not shared)
240V/40 amp circuit protected by an appropriate
branch circuit supply.
• The service cord on your range is fitted with a standard
four (4) prong type 14-50P plug (matching receptacle
14-50R).
The method of connection to the mains electricity supply
must facilitate complete electrical isolation of the appliance.
The mains connection and isolation should not be positioned
above the range and must be positioned within the area
defined in Fig. 29.2.
THIS RANGE MUST BE COMPLETELY ISOLATED FROM THE
ELECTRICITY SUPPLY BEFORE SERVICING. THE RANGE
IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING
PLATE, WHICH IS SITUATED BEHIND THE PLINTH COVER.
WARNING: THIS APPLIANCE MUST BE EARTHED.
n
THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED
ON THE RATING PLATE, WHICH IS SITUATED BEHIND THE
PLINTH COVER.
IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED
BY THE MANUFACTURER, ITS SERVICE AGENT OR
SIMILARLY QUALIFIED PERSON TO AVOID A HAZARD.
The rating plate is located behind the removable plinth, see Fig. 29.2.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person to avoid a hazard.
Electrical Grounding is required on this appliance.
DO NOT connect to the electrical supply until the appliance is permanently grounded.
This appliance must be connected to a grounded, metallic, permanent supply. Or a grounding
connector should be connected to the grounding terminal or wire lead on the appliance.
Failure to follow these instructions could result in death or serious injury.
Electric Shock Hazard
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Er7 100-3Er7 150-5

Table of Contents