Settings - Cebora POWER SPOT 5700 Instruction Manual

5.3.1

Settings

Press the knob G for at least 2 seconds to open the "Process Params" (Process Parameters) menu.
The following parameters are selectable from this menu:
To access each parameter, select it by turning the knob G and then press it for less than 2 seconds.
Once you have accessed the parameter, turn the knob G to make the desired choice and then press it again for less
than 2 seconds to confi rm the choice made and go back to the menu with the list of parameters. To go back to the
initial screen, press the knob G for more than 2 seconds.
• "Stud Material" parameter.
• "Base Material" parameter
• "Spring Force" parameter
It is possible to change the voltage by means of the knob G, whereas the force displayed on the scale P can be
changed by means of the knob Q.
• "Language" parameter
22
The value can be changed by means of the knob Q.
Note: if the force on the gun is changed from the proposed value, we recommend
adjusting this value. The newly changed value will appear on the display and next to it an
arrow pointing downward if the value was decreased or upward the value was increased.
Based on the choices made, the force and voltage to be used will be indicated on the
display.
- Stud Material
- Base material
- Spring Force
- Language
- Measure system
- LCD contrast
- Factory Setup
3300103/D 3301291