Table of Contents
Advertisement
90
STARTING AND OPERATING
Brief full-throttle acceleration within the limits of local
traffic laws contributes to a good break-in. Wide-open
throttle acceleration in low gear can be detrimental and
should be avoided.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
For the recommended viscosity and quality grades see
page 305.
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil in
the engine or damage may result.
NOTE:
A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should
be considered a normal part of the break-in and not
interpreted as a problem. Please check your oil level
with the engine oil indicator often during the break-in
period. Add oil as required.
ENGINE BREAK-IN RECOMMENDATIONS –
SRT
The following tips will be helpful in obtaining optimum
performance and maximum durability for your new SRT
Vehicle.
This break-in occurs mainly during the first 500 miles
(805 km) and continues through the first oil change
interval.
It is recommended that the operator observe the follow-
ing driving behaviors during the new vehicle break-in
period:
0 to 100 miles (0 to 161 km):
•
Do not allow the engine to operate at idle for an
extended period of time.
•
Press the accelerator pedal slowly and no more
than halfway to avoid rapid acceleration.
•
Avoid aggressive braking.
•
Drive with the engine speed below 3,500 RPM.
•
Maintain vehicle speed below 55 mph (88 km/h)
and observe local speed limits.
100 to 300 miles (161 to 483 km):
•
Press the accelerator pedal slowly and no more
than halfway to avoid rapid acceleration in lower
gears (FIRST to THIRD gears).
•
Avoid aggressive braking.
•
Drive with the engine speed below 5,000 RPM.
•
Maintain vehicle speed below 70 mph (112 km/h)
and observe local speed limits.
300 to 500 miles (483 to 805 km):
•
Exercise the full engine RPM range, shifting manu-
ally (paddles or gear shift) at higher RPM when
possible.
•
Do not perform sustained operation with the accel-
erator pedal at wide open throttle.
•
Maintain vehicle speed below 85 mph (136 km/h)
and observe local speed limits.
For the first 1,500 miles (2,414 km):
•
Do not participate in track events, sport driving
schools, or similar activities.
NOTE:
Check engine oil with every refueling and add if neces-
sary. Oil and fuel consumption may be higher through
the first oil change interval. Running the engine with an
oil level below the add mark can cause severe engine
damage.
PARKING BRAKE
Before leaving the vehicle, make sure that the parking
brake is fully applied and place the gear selector in the
PARK (P) position.
The foot operated parking brake is located below the
lower left corner of the instrument panel. To apply the
parking brake, firmly push the parking brake pedal fully.
To release the parking brake, press the parking brake
pedal a second time and let your foot up as you feel the
brake disengage.
Parking Brake
When the parking brake is applied with the ignition
switch in the ON/RUN position, the Brake Warning Light
in the instrument cluster will illuminate.
Advertisement
Table of Contents
