Table of Contents
Advertisement
Power Inverter
The power inverter is designed with built-in overload
protection. If the power rating of 150 W is exceeded,
the power inverter automatically shuts down. Once the
electrical device has been removed from the outlet the
inverter should automatically reset. To avoid overload-
ing the circuit, check the power ratings on electrical
devices prior to using the inverter.
WARNING!
To avoid serious injury or death:
•
Do not insert any objects into the receptacles.
•
Do not touch with wet hands.
•
Close the lid when not in use.
•
If this outlet is mishandled, it may cause an elec-
tric shock and failure.
WIRELESS CHARGING PAD —
IF EQUIPPED
Wireless Charging Pad
Your vehicle may be equipped with a 15W 3A Qi® wire-
less charging pad located below the center stack,
within the storage compartment. This charging pad is
designed to wirelessly charge your Qi® enabled mobile
phone. Qi® is a standard that allows wireless charging
of your mobile phone.
Your mobile phone must be designed for Qi® wireless
charging. If the phone is not equipped with Qi® wireless
charging functionality, an aftermarket sleeve or a spe-
cialized back plate can be purchased from your mobile
phone provider or a local electronics retailer. Please
see your phone's Owner's Manual for further
information.
The wireless charging pad is equipped with an anti-slip
mat to hold your mobile phone in place, and an LED
indicator light.
GETTING TO KNOW YOUR VEHICLE
Place the device inside the prepared area delimited in
the mat as shown in the image. Incorrect positioning
will prevent the phone from charging.
LED Indicator Status:
•
No Light: Charging pad is idle or searching for a
device. Device may not be compatible with the Qi®
standard.
•
Blue Light: Device is detected and is charging.
•
Red Light/Flashing: Internal error, or foreign object
is detected.
•
Green Light: Device has completed battery charging
(if device is equipped to transmit this information).
Important Notes Regarding This Vehicle's Wireless
Charging Pad:
•
The presence of the Near-Field Communication
(NFC) function active on a smartphone could signal
malfunction anomalies.
•
The ignition must be in the ON/RUN position in
order for the phone to charge.
•
To avoid interference with the key fob search, the
wireless charging pad will stop charging when any
door or liftgate is opened, even if the engine is
running.
•
Be sure to place the mobile device correctly (display
facing upward, and phone not covering the LED) on
the wireless charging pad.
•
If the phone moves on the pad causing the red light
to illuminate, the phone will have to be picked up
and placed back on the charging pad to resume
charging.
•
Wireless charging is not as fast as when the phone
is connected to a wired charger.
•
The phone's protective case must be removed when
placed on the wireless charging pad.
59
2
Advertisement
Table of Contents
