Table of Contents
Advertisement
5.4.1
Route the Wiring
Note: DO NOT bend wire at a 90° angle when routing
through materials. A minimum 1.9 cm (3/4 in.)
bending
radius
Figure 5-13.
1.9 cm [3/4]R min.
Note: Dimensions are in cm [in.] and not to scale.
Figure 5-13 Routing Wire Bend Radius
1. Locate the 6P/RJ25 connector end of the remote
display cable.
2. Route the 6P/RJ25 connector end of the remote
display cable
through the cutout opening. See
,
Figure 5-14.
4
1
3
1. Drilled mounting holes
2. Cutout opening
3. Screw, mounting (qty. 4)
4. Mounting holes
Figure 5-14 APU Controller Mounting Assembly
3. Locate the P6 or 9-pin connector end of the load
connection harness. See Figure 5-15.
Figure 5-15 P6 or 9-Pin Connection on Load
Connection (Power) Harness
26
Section 5 Electrical System
is
recommended.
2
4. Route the P6 or 9-pin connector end of the load
connection harness
See Figure 5-14.
See
5.4.2
Connect the Wiring
1. Connect the P6 or 9-pin connector end of the load
connection harness to the P6A or 9-pin connector
See Figure 5-16.
1
Back View
1
1. Mounting holes
2. Harness, connection point, HVAC, 6P/RJ25
3. Harness, connection point, controller, P6A or 9--pin
Figure 5-16 Back Side of APU Controller
2. Connect the 6P/RJ25 connector end of the remote
display cable into the customer interface remote
display cable connection point. See Figure 5-16.
3. Use rubber grommets and nonreleasable cable
ties as necessary to protect and secure the wiring
from sharp objects, exhaust system, water, and
any moving parts.
4. Proceed to Section 5.4.3, Mount and Secure the
APU controller.
5.4.3
Mount and Secure the Remote
APU Controller
1. Align the mounting holes to the drilled mounting
holes. See Figure 5-14.
2. Place #8 x 3/4 in. mounting screws into the
mounting holes and tighten securely.
Figure 5-14.
through the cutout opening.
,
1
2
3
1
TP-6583 3/08
.
See
Advertisement
Table of Contents
