Related Manuals for Winco WL12000HE/K
Summary of Contents for Winco WL12000HE/K
- Page 1 INDUSTRIAL PORTABLE INSTALLATION AND OPERATORS MANUAL WL12000HE/K WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831...
-
Page 2: Table Of Contents
Should you experience a problem please follow the “Troubleshooting Tables” near the end of this WL12000HE/K MODEL manual. The warranty listed in the manual describes what you can expect from WINCO should you need SERIAL NUMBER_________________________ service assistance in the future. PURCHASE DATE_________________________ TABLE OF CONTENTS... -
Page 3: Safety Information
SAFETY INFORMATION b. Keep fuel containers out of reach of children. c. Do not smoke or use open flame near the generator set or fuel tank. This engine generator set has been designed and d. Keep a fire extinguisher nearby and know its manufactured to allow safe, reliable performance. proper use. Fire extinguishers rated ABC by Poor maintenance, improper or careless use can NFPA are appropriate. -
Page 4: Unit Capabilities
TESTING POLICY UNIT CAPABILITIES Before any generator is shipped from the factory, it GENERATOR CONNECTIONS is fully checked for performance. The generator is loaded to its full capacity, and the voltage, current Wl12000HE: 120 volt and 240 volt receptacles and frequency are carefully checked. are provided for connection to various loads. -
Page 5: Preparing The Unit
SAE 10W-30 or 5W-30 is recommended for general use. Use a full synthetic 5W-30 for starting/operating temperatures between 5°F ( 15°C) and 13°F ( 25°C). Other viscosities shown in the chart − − − may be used when the average temperature in your area is within Self-exciting generators respond to severe overload- LUBRICATION the indicated range. -
Page 6: Battery Installation
GASOLINE BATTERY INSTALLATION When using gasoline, always use fresh, clean, This engine generator set is shipped with a battery tie unleaded fuel. This engine is certified to operate on down kit for customer installation. This kit consists of unleaded gasoline with a minimum octane rating of a battery tie down and hardware for installation of the 87 or higher. -
Page 7: Basic Operation
OIL ALERT SYSTEM This WINCO Industrial generator is equipped with a low oil shutdown system. This Honda engine uses an float switch mounted inside the engine. If the oil level drops below a certain point the low oil module on the engine will shut it down. -
Page 8: Stopping & Storage
Z6L600_005 bout 1/3 Warm up the engine for 2 or 3 minutes. 3. Pull the choke out to the full “closed” position. A 7. Gradually push the choke to the open position as If the choke knob was pulled to the CLOSED position to start the warm engine will require less choking than a the engine warms up.. -
Page 9: Operating Speed
Reference “D” below is the speed adjustment for While the engine is warm, drain the oil and this engine. refill with fresh oil. Clean dirt and chaff from cylinder, cylinder head fins, blower housing, screen and muffler areas. Store in a clean and dry area. OPERATING SPEED The engine-generator must be run at the correct speed in order to produce the proper electrical volt- age and frequency. -
Page 10: Wiring
CAUTION: EQUIPMENT OVERLOAD WIRING Keep the generator load within the generator and Plug your tools such as drills, saws, blowers, sump receptacle nameplate rating. Overloading may cause pump and other items to be powered directly into damage to the generator and/or the loads . the generator receptacles. -
Page 11: Engine Care
Emergency Transfer/Service local telephone directory under “Engines-Gasoline” 09/07/07 20:34:57 32Z6L600_008 (ET/S) system available through your WINCO dealer. for the closest engine repair center or ask the dealer The emergency distribution panel must be installed from whom you purchased the power plant. -
Page 12: Generator Care
g. Remove oil filler plug and refill with new oil. f. To loosen debris, gently tap the air filter on a Refer to the table on page 5 for the proper hard surface. If the air filter is excessively dirty grade of oil based on your operating replace with a new filter. You can use pres- temperature. surized air (not to exceed 30 psi.) to clean the filter. Always blow the compressed air from NOTE: This engine requires 57 to 58 ounces of oil inside to the outside. if it is completely drained. Use caution when refilling g. Wash the foam filter element in liquid detergent the engine as some residual oil may have remained... -
Page 13: Troubleshooting
2. Generator Maintenance - Any major generator Voltage too low *Engine speed is too low. service, including the installation or replacement *Generator overloaded. of parts, should be performed only by a qualified *Defective stator. electrical service technician. USE ONLY FACTORY *Defective rotor (field). APPROVED REPAIR PARTS. *Defective Capacitor. ——————————————————————— a. Bearing - The bearing used in these generators Circuit Breaker *Defective load. - Page 14 2015-00 60706-233...
- Page 15 THERE IS NO OTHER EXPRESS WARRANTY. To the extent permitted by law, any and all warranties, including those of merchantability and fitness for a particular purpose, are limited to 24 months from date of purchase. In no event is WINCO liable for incidental or consequential damages. Note: Some states do not allow limitation on the duration of implied warranty and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply in every instance. This warranty gives you specific legal rights which may vary from state to state.
- Page 16 WINCO recommends that you retain all receipts covering maintenance on your genera- tor, but WINCO cannot deny warranty solely for lack of receipts. As the generator owner, you should be aware that WINCO may deny you warranty coverage if your genera- tor or a part has failed due to abuse, neglect, or improper maintenance or unapproved modifications.
Need help?
Do you have a question about the WL12000HE/K and is the answer not in the manual?
Questions and answers