Switching To Wide View When Backing Up - Hyundai IONIQ 5 Owner's Manual

NOTICE
• You can control the DSM cameras
when the Start/Stop button is in the
OFF position, but excessive control
may discharge the vehicle's battery.
• Always use the DSM camera folding
button to fold or unfold the DSM
cameras. Folding or unfolding the
cameras manually may damage the
motor. Also, vibrations or noises may
be emitted from the DSM cameras
while driving, indicating that the
gears are not engaged correctly.
In this case, engage the gears by
folding and unfolding the camera
again using the folding button.
• When cleaning the DSM camera
lenses or the DSM monitors, do not
spray the cleaner directly. Instead,
coat it on a soft towel or cloth. If you
spray the cleaner directly on the
lenses or monitors, the cleaner may
get inside, causing a malfunction.
• Do not scrape ice off the surface of
the DSM camera lenses. Doing so
may damage the lenses.
• Do not use warm or hot water to
remove snow or ice from the camera
lenses. Doing so may cause cracks in
the lenses.
• If the DSM camera is jammed with
ice, do not adjust the camera by
force. Use an approved de-icer spray,
or move the vehicle to a warm place
and allow the ice to melt.
Switching to wide view when
backing up
Information
• The guidelines displayed on the DSM
monitors while backing up indicate the
following points.
- 0.3 m (11 in.) away from the side of
the vehicle
- 0.5 m (11 in.) and 1 m (39 in.) away
from the rear of the vehicle
• The wide view will be deactivated when
you shift to N (Neutral) or D (Drive)
and drive at a speed of 10 km/h (6 mph)
or faster.
• The wide view appears only when the
wide view switch feature is activated
while backing up. In P (Park), N
(Neutral), and D (Drive), the DSM
monitors display the original view.
05
ONE1051232 ONE1051232
5-43