Advertisement
3. Wire stream "Output 1" with micnode2 plugin's "Analog Input 1 RX".
IMPORTANT: IP address and port need to be equally configured as in Network streams in nnounce configuration UI.
Using Built-in Paging Dashboard
To use the built-in paging dashboard of the micnode2 paging station, configure zones in the Q-Sys designer micnode2
plugin.
1. Go to micnode2 plugin Properties.
2. Set the Enable Paging config value to "Yes".
3. Define the desired number of Zone Group Count:
4. Configure zone buttons:
Zones are now ready to use in micnode2 paging station.
15
Advertisement
Need help?
Do you have a question about the nnounce Micnode2 and is the answer not in the manual?
Questions and answers