Table of Contents
Advertisement
MOON PHASE
In the Northern hemisphere, the moon
waxes (the part of the moon we see
that glows after the New Moon) from the
right. Hence the sun-lit area of the moon
moves from right to left in the Northern
Hemisphere, while in the Southern
Hemisphere, it moves from left to right.
Below is the table which illustrate how the
moon will appear on the console.
MAINTENANCE
TO CLEAN THE RAIN COLLECTOR
1. Rotate the rain collector by 30° anticlockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or insects.
4. Install all the parts when they are fully clean and dried.
TO CLEAN THE THERMO / HYGRO SENSOR
1. Unscrew the 2 screws at the bottom of the radiation shield.
2. Gently pull out the shield.
3. Remove carefully any dirt or insects inside the sensor casing (Do not let the sensors inside get wet).
4. Clean the shield with water and remove any dirt or insects.
5. Install all the parts back when they are fully clean and dried.
TROUBLESHOOTING
Problem / Symptom
Strange or no measurement of Rain Sensor
Strange or no measurement of Thermo /
Hygro Sensor
Strange or no measurement of Wind Speed
and Direction
and
(Signal lost for 15 minutes)
and
(Signal lost for 1 hour)
Northern
hemisphere
Waxing Crescent
Waxing Gibbous
Waning Gibbous
Waning Crescent
N
1. Check the drain hole in the rain collector.
2. Check the balance indicator.
1. Check the radiation shield.
2. Check the sensor casing.
1. Check wind cups (Anemometer).
2. Check the wind vane.
1. Relocate the console and 5-in-1 sensor closer to each
other.
2. Make sure the console is placed away from other
electronic appliances that may interfere with
the wireless communication (TVs, computers,
microwaves).
3. If problem continues, reset both console and 5-in-1
sensor.
15
Moon Phase
New Moon
First quarter
Full Moon
Third quarter
N
"Lock" Position
Solution
Southern
hemisphere
N
"Unlock" Position
Advertisement
Table of Contents
