TDK-Lambda ZWS-C Series Instruction Manual page 7

5. Terminal connecting method
Pay attention to the input wiring. If it is connected to wrong terminal, the power supply will be damaged.
• Input must be off when making connections.
• Connect
terminal and mounting hole to protective earth (frame ground of the equipment etc.) of the equipment in
Class I insulation.
When connecting the
• The output load line and input line shall be separated to improve noise sensitivity.
• Do not apply stress to PCB, when connecting or removing connector.
• Use input/output connector (housing) specified by the table below.
• Use recommended crimping tool. Connector is not included with this product. (Refer to the following)
ZWS10C/ZWS15C
CN1
L
3
INPUT
1
N
CN2
Connector / Housing and terminal Pin
Terminal Symbol
Input connector CN1
Output connector CN51
FG TAB CN2
Matching housing and terminal --- Not included with the product
Hand Crimping Tool
Hand Crimping Tool Terminal Pin
SVH-21T-P1.1
YC-160R
or BVH-21T-P1.1
YC-930R SVH-41T-P1.1
YC-931R or BVH-41T-P1.1
terminal to a protective earth, use a thick wire for safety and improvement of noise sensitivity.
CN51
-
1
OUTPUT LOAD
+
2
COMPONENT SIDE
Connector
B2P3-VH(LF)(SN)
B2P-VH(LF)(SN)
-
Maker
J.S.T.
<Page>
ZWS30C
CN1
L
3
INPUT
1
N
CN2
Housing
VHR-3N
(AWG#22 ~ AWG#16)
SVH-21T-P1.1 or BVH-21T-P1.1
SVH-41T-P1.1 or BVH-41T-P1.1
VHR-2N
(AWG#20 ~ AWG#16)
STO-21T-250N
(AWG#22 ~ AWG#18)
STO-61T-250N
(AWG#18 ~ AWG#14)
7/17
TDK-Lambda
ZWS10C • 15C • 30C Series
INSTRUCTION MANUAL
CN51
-
1
OUTPUT LOAD
+
2
COMPONENT SIDE
Terminal Pin Maker
J.S.T.
-