Related Manuals for Sentera Controls ECMF8-EW
Summary of Contents for Sentera Controls ECMF8-EW
- Page 1 ECMF8-EW/WF HVAC CONTROLLER FOR EC FANS / VFD WITH INTERNET GATEWAY Mounting and operating instructions...
-
Page 2: Table Of Contents
PRODUCT DESCRIPTION ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS LED INDICATIONS MOUNTING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 2 - 10 www.sentera.eu... -
Page 3: Ecmf8-Ew/Wf
In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 3 - 10 www.sentera.eu... -
Page 4: Product Description
WITH INTERNET GATEWAY PRODUCT DESCRIPTION ECMF8-EW/WF is a fan speed controller with Modbus RTU communication, two analogue/modulating/digital inputs, two tacho inputs and two analogue/modulating outputs for connecting EC fan(s) or a VFD. The device can be used for single or dual... -
Page 5: Standards
Part 17: ► Specific conditions for Broadband Data Transmission Systems; Harmonised Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 5 - 10 www.sentera.eu back to the table of contents... -
Page 6: Wiring And Connections
Do not connect external power supply to this RJ45 socket. 11 - Ethernet (EW To connect the installation to SenteraWeb via a LAN cable only) MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 6 - 10 www.sentera.eu back to the table of contents... -
Page 7: Led Indications
GND / Ain2 & GND) to an external potentiometer or HVAC sensor with an analogue / modulating output (0—10 VDC / 0—20 mA / PWM / digital (0 or1)) MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 7 - 10 www.sentera.eu... - Page 8 If applicable, connect the Modbus RTU communication cables. If your device is ECMF8-EW version, connect the Ethernet cable (Ethernet connection is the default setting). Connect HVAC sensors, potentiometers or other slave devices to the RJ45 socket and/or Power over Modbus (PoM) terminal block (see Fig.
-
Page 9: Verification Of Installation
The manufacturer bears no responsibility for any misprints or mistakes in this data. MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 9 - 10 www.sentera.eu... - Page 10 In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-ECMF8-EW-WF-EN-000 - 20 / 09 / 2023 10 - 10 www.sentera.eu...
Need help?
Do you have a question about the ECMF8-EW and is the answer not in the manual?
Questions and answers