Advertisement
2.2.2 Transportation procedures
(1) RH-6FH series
No.2 arm
<3>
No.1 arm
Base
Fixing plate A
Fig.2-2 ： Transportation of robot arm
1) The robot must be transported by two workers with putting the fixing plate A and B. Place the robot on a
cart, etc., and move it to near the installation place. Transporting the robot with the following should be lim -
ited to placing the robot on the frame or cart, and to positioning.
2) When transporting the robot arm, one person should hold the fixing plate A of No.2 arm <1> and No.2 arm
<2> and another person should hold the fixing plate A of base <3>. When transporting the robot, do not apply
force to the cover, or apply a strong shock on the robot.
3) Remove the fixtures after installing the robot.
4) When using the model with chemical-resistant specifications (SExx01), install the attached rubber plug.
When you use a stopper for operating range change optional, install them first. And install the attached rub -
ber plug to the screw hole which is not used. Use a liquid type gasket to fix the rubber plug and seal the
screw hole.
Recommendation gasket: 1212 (Supplier: ThreeBond Holdings Co., Ltd.)
5) Always attach the fixing plate, and follow the above procedures and methods to transport the robot for
secondary transportation, such as when changing the installation position.
If the arm is directly holded without using the specified fixing plate, or if it is holded in the work posture, the
configuration devices could be damaged, and the transportation workers will be subject to risk due to an
inadequate center of gravity position.
CAUTION
CAUTION
CAUTION
A
<1>
To prevent accidents, do not hold the robot from the left/right sides, or hold covers that
have no grips.
Be careful not to apply force to the shaft section (J3 axis). The shaft may be damaged
and the overload error may occur at the time of movement.
When installing the fixing tool again, place the robot in the posture where each axis
shows the values listed in the table below.
Mass
RH-6FH35** series: Approx. 39kg
RH-6FH45** series: Approx. 40kg
RH-6FH55** series: Approx. 41kg
<2>
Fixing plate B
Screw holes which are used by
optional stopper for operating
range change. (4 places)
View A
2Unpacking to Installation
注意 CAUTION
VORSICHT
ロ ボ ッ ト の 運 搬 は 、 図 の 姿 勢 の よ う に
２ 人 で お こ な っ て く だ さ い 。
T h e r o b o t m u s t a l w a y s b e
t r a n s p o r t e d b y t w o w o r k e r s .
B e i e i n e m T r a n s p o r t s o l l t e
d e r R o b o t e r v o n 2
P e r s o n e n a n d e n i n d e r
A b b i l d u n g g e z e i g t e n S t e l l e n
a n g e h o b e n w e r d e n .
Installation
2-8
Advertisement
