Dip Switches - Viking E-1600A-BLT-EWP Technical Practice

B. Mounting
E
M
E
R
Front
42.0"
G
View
E
N
C
Y
3.0" 6.0"
Step 1. Mount the tower phone approximately 42" above the floor to a flat, sturdy surface using 5/16 hardware.
washers should be used on the main mounting bolts for additional strength.
Step 2. Locate the strobe light panel and pass the red and black wires from the strobe panel through the gasket and the upper
hole in the tower.
Step 3. Mount the strobe panel to the tower using the four security screws provided.
Step 4. Locate the phone panel. Using the gel-filled butt connectors, connect the red and black wires labeled "Strobe Light" to
the red and black wires on the strobe panel.
Step 5. Connect the phone line to the red and green wires (this connection is not polarity sensitive).
Step 6. Connect the 12V DC adapter wires black (+) and black with white stripe (-) to the red with black stripe (+) and black with
white stripe (-) wires from the LDB-3 control module.
Step 7. Mount the phone panel to the tower using the remaining four security screws.
A. DIP Switches
Description
Sw 1
Sw 3
Ring Indication Only.
ON
OFF
Off-Hook/Loop Current Detection Only.
OFF ON
Ring and Off-Hook/Loop Current Detection.
ON
ON
Sw 2
Ring Cadence Mode (see section B)
ON
Ring Cadence Mode ON - strobe remains activated in between rings.
OFF Ring Cadence Mode OFF - strobe is activated only during ringing.
0.35"
Diameter
High Visibility
Safety Yellow
Powder Paint
Use 5/16" bolt
and flat washer
(included)
Bottom View
2.87"
1.37"
Knockout for
1/2 inch conduit
Condensation
Drain Hole
0.35"
Diameter
3.0"
3.12"
Rear
View
35.76"
1.5"
0.875"
1.25"
Diameter
Strobe Panel Mounting
1 Million Candle
Power Blue Strobe Light
(4) Stainless steel spanner head
screws (bit and screws included)
Adhere gasket to chassis,
centering over mounting holes
Phone Panel Mounting
Rain Guard (included)
N C Y
R G E
E M E
N E
P H O
P
H E L
Grade 2 Braille Label
I N F O
L
C A L
T E D
N E C
C O N
"Help" Push to Call Button
Call Connected Red LED
"Info" Push to Call Button
(E-1600A-BLT2-EWP Only)
(4) stainless steel spanner
head screws (included)
Condensation Drain Hole
Adhere gasket to chassis,
centering over mounting holes
S1
ON
OFF
1 2 3
Flat
11
10
9
8
7
6
5
4
3
2
1
3