Panasonic DVCPRO AJ-D455P Service Manual page 93

6. AUDIO (F1) and
RF/CUE
6-1. Setting
1. Set the audio impedance switches on the Audio
(F1) board as shown below.
SW100 : HIGH
2. Set the Front Switch as shown bellow.
REC VR(CH1,CH2)
Audio IN
REMOTE/LOCAL
HEAD PHONES
HP VR
1. Set the Audio Analyzer as shown below.
Audio Analyzer
GENERATOR OUTPUT
ANALYZE CHA INPUT
ANALYZE CHB INPUT
UNIT SETTING
<Service Menu Setting>
1. Open the Service Menu. (Refer to SEC1 Service
Information.)
2. Select the G00: AUDIO ADJUST.
3. Set the items as shown below
MENU
G01:REF LEVEL1
G02:REF LEVEL2
G03:REF LV INI
G09:LINE OUT CUE
<User Menu Setting>
1. Open the User Menu and set the items as shown
below.
MENU
700 CH1 IN LEV
701 CH2 IN LEV
703 CH1 OUT LEV
704 CH2 OUT LEV
713 MONI CH SEL
714 REC CH1
715 REC CH2
716 REC CUE
718 DV OUTPUT
719 PB FADE
720 EMBEDED AUD
721 LINE CH SEL
722 INT SIG
725 CUE SLOW
731 DV REF LV
SW101 : HIGH
Center
ANALOG
LOCAL
ST
Center
50W
(A&B, BAL, FLOAT)
100KW
100KW
dBu
Setting
Fs-20
0dB
0dB
OFF
Setting
0dB
0dB
0dB
0dB
AUTO1
CH1
CH2
CH1
ST1
AUTO
ON
PCM
OFF
STEP
DV
6-2. CH1, CH2 Output Level
Adjustment
BOARD
AUDIO (F1)
TP AUDIO OUT (CH1, CH2)
ADJ. VR300 (CH1 OUT LV)
VR301 (CH2 OUT LV)
TAPE -----
INPUT INT SIG
MODE EE
M. EQ
Oscilloscope, Monitor TV,
Audio Analyzer
SPEC.
1. Set the SET-UP MENU as shown bellow.
722 INT SIG : ON
2. Adjust VR300 so that the CH1 level is in the
specification.
3. Adjust VR301 so that the CH2 level is in the
specification.
4. Confirm that the level meter on the front panel is
displayed at –20dB.
6-3. CH1, CH2 Input Level
Adjustment
BOARD AUDIO (F1)
TP
AUDIO OUT (CH1, CH2)
ADJ. VR200 (CH1 IN LV)
VR201 (CH2 IN LV)
TAPE -----
INPUT LINE IN CH1,2 (1KHz 0dBu, Sinewave)
MODE EE
M. EQ Oscilloscope, Monitor TV,
Audio Analyzer
SPEC.
1. Adjust VR200 so that the CH1 level is in the
specification.
2. Adjust VR201 so that the CH2 level is in the
specification.
ELE-36
0dBu ± 0.2dB
0dBu ± 0.2dB