Software Version Upgrade Method; Version Upgrade For The Servo Microcomputer With Built-In Flash Memory - Panasonic DVCPRO AJ-D455P Service Manual

9. Software Version Upgrade Method

9-1. Version Upgrade for the SERVO M icrocom puter w ith Built-in Flash M em ory
The SERVO microcomputer of the F7: SERVO circuit board has a built-in flash memory. For the software version
up, connect the "Flash memory version up tool (VFK1304A)" to the tool connection connector and use the "Servo
version up software (VFK1503)" according to the following procedure.
F7: SERVO circuit board
1. Prepare a personal computer (MS-DOS, Windows 95 or 98).
2. Copy the servo version up software (VFK1503) and the new servo microcomputer software into the same
directory of the personal computer. (The following four types of software.)
Version up software (VFK1503)
Servo microcomputer software
3. Confirm the switch settings for the "Flash memory version up tool (VFK1304A)".
SW1-1: ON
SW1-2: ON
4. Connect the AJ-D455P, the "Flash memory version up tool (VFK1304A)", and the personal computer as
shown below. Pay attention not to confuse the connection direction (rear, front) for the flat cable of the tool
(VFK1304A).
RS-232C cable
PC
Tool connection connector(P202)
SW1-3: OFF
SW1-4: OFF
Flash memory version
up tool (VFK1304A)
INF-13
(SERVO) with built-in
flash memory (IP201)
"fw103u.exe"
"vsiXXXX.obf"
"vsiXXXX.bat"
"vsiXXXX.ex"
F7: SERVO
P.C.Board (P202)
AJ-D455P
Microcomputer