Table of Contents
Advertisement
6. Remove knock out from bottom of firebox by using a
hammer (Figure 18.3).
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side (Figure 19.1).
8. Slide the ash door over the 8 screws protruding from the
bottom of the appliance. Secure with nuts and washers
using 7/16 socket wrench (Figure 19.1).
9. Install ARS latch by sliding latch assembly over 2
threaded studs protruding from the bottom on the left
hand side of the appliance. Secure by using two nuts
use 7/16 socket wrench (Figure 19.2).
10. Add knob to handle rod (Figure 19.2).
11. Use 2 bolts and two flange nuts to secure ARS channel
using 3/8 open end wrench and 7/16 socket wrench
(Figure 19.4).
Installing Queen Anne Leg ARS Kit
1. Follow Beginning installing the ARS system instructions
provided on page 18.
2. Install ARS Spacer on left hand side with one bolt using
Phillips head screwdriver (Figure 19.5).
3. Install leg brackets and ash drawer using four screws
using Phillips head screwdriver.
Start bottom two bolts through ash drawer, leg brackets
and into the bottom of the appliance (Figure 21.1).
Align top holes and repeat; secure all four bolts.
4. Install legs onto leg brackets making sure the legs
are up against the bracket and secure with bolts and
washers using a 3/8 open end wrench (Figure 21.2).
5. Install leveling bolts into 2 legs; these leveling legs
should be in opposite corners (Figure 21.2).
6. Carefully stand appliance up and place in desired
location.
7. Use leveling bolts on legs to stabilize and level appliance
(Figure 21.3).
Finishing the ARS Installation
1. Replace 2 front bricks that were removed (Figure 21.4).
2. Install the ash drawer to ASH Removal receiver.
3. Install ARS access cover inside of ARS Channel that is
located inside the firebox (Figure 21.4).
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
• Verify that the baffle boards and ceramic blanket are
in their proper locations.
• It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
21
CAUTION
Lay appliance flat on
its back on protective
padding or pallet
Leg Brackets
Figure 21.1
Figure 21.2
Figure 21.3
ARS Access
Cover
Figure 21.4
7037-806A
Align top holes
and repeat; secure
Ash Removal Box
Insert 2 bottom screws loosely
Leveling Legs at
Opposite Corners
Reinstall 2 front
bricks back into
firebox
Ash Drawer
05/21
Advertisement
Table of Contents
