Omada Stackable L3 Managed Switch
Management Port
Designed to connnect the device for management through web, CLI or SNMP.
Console Port
Designed to connect with a computer for monitoring and configuring the switch. When the switch has an
RJ45 console port and a Type-C console port, console input is active on only one console port at a time.
By default, the Type-C connector takes priority over the RJ45 connector, or you can change the priority
through the web.
USB Port
Designed to install the USB flash disk for data storage.
10/100/1000 Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100 Mbps or 1000 Mbps. For PoE
switches, the port can also provide power for PDs.
SFP+ Slot
Designed to install the 10 Gbps/1 Gbps optical module.
SFP28 Slot
Designed to install the 25 Gbps/10 Gbps/1 Gbps optical module.
Port Feature
10/100/1000 Mbps
Model
SG6428X
SG6428XHP
SG6654X
SG6654XHP
SX6632YF
Rear Panel
■
The rear panel of
SG6428X/SG6654X
purposes only. Your switch may differ in appearance from the depicted.
Note:
PWR1 is the primary power supply and it takes priority over PWR2.
06
Introduction
SFP+ Slot SFP28 Slot
RJ45 Port
24
4
24
4
48
6
48
6
/
26
is shown as the following figure. The figure is for demonstration
Kensington
Security Slot
Management Port
/
1
/
1
/
1
/
1
6
1
Grounding Terminal
Power Socket
Console Port
USB Port
2
2
2
2
2
2
2
2
2
2