Mercedes-Benz GLE 2022 Operator's Manual page 668

666 Wheels and tyres
Aluminium hub cap
To remove:
Position socket 2 from the tyre-change tool
#
kit on hub cap 1.
3 on socket 2.
Position wheel spanner
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
To fit:
Follow the instructions above in reverse order.
#
%
Specified tightening torque: 25 Nm.
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change ( page 665).
/
Important notes on using the jack:
Use only a vehicle-specific jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large, flat,
1
load-bearing, non-slip underlay.
The foot of the jack must be positioned verti-
R
cally under the jack support point.
F167 0009 02
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the vehi-
R
cle.
Never lie under the vehicle.
R