Charging Recommendations; Removing The Robot From The Pool; Using The Grab Hook; Tm Clicker (Liberty 300 + 400) - Maytronics Dolphin Liberty 200 User Instructions

4. CHARGING RECOMMENDATIONS

• When the battery is low and all indicators are off - the cleaner is on standby mode. Connect the charger to the
robot to wake it up.
• Always charge the pool cleaner in a protected and shaded area at a temperature range of
6°C - 35°C / 43°F - 95°F, until you see 3 green bars in the battery indicator panel (up to 6 hours).
• Make sure that the charger surface and power unit surfaces are clean, and there is no object between the robot
and the charger.
• The charger is rainproof, the robot can be charged when wet. However, do not put the charger in the water. It is
not designed to be underwater.

5. REMOVING THE ROBOT FROM THE POOL

5.1 Grab hook
Pull robot to waterline, then grab it.
*
* Standard pole, not included
5.2 ClickUp
TM
- LIBERTY 300 & 400
After the cleaning cycle, shake the Clicker inside the water for over 3 seconds and the robot will climb its
nearest wall. The robot needs to finish its cycle before it can be called up with the Clicker.
In regular mode, the feature will be available for 6 days after the cleaning cycle ends.
Please note: When in Eco Mode, you can use the Clicker between cycles and at the end of the third cycle,
however using the clicker will cancel the Eco Mode.
5.3 End of Cycle Pickup
In the last few minutes of its cleaning cycle, it will climb each wall and wait 20 seconds to be taken out.
If you started the cycle with the app, you will get a push notification on your phone to let you know the
robot is waiting. If it isn't picked up, it will wait on the floor near a wall. You can then use the Clicker or
hook to take it out.
5
1
1
- LIBERTY 400
2
2
Robotic Pool Cleaner LIBERTY
3
3
| User Instructions