Follett Horizon Elite HCF1010RMS Installation Instructions Manual
Ice machine with ride technology installation instructions for ice manager diverter valve
Hide thumbs
Also See for Horizon Elite HCF1010RMS:
- Installation instructions manual (17 pages) ,
- User manual (21 pages)
Table of Contents
Advertisement
Quick Links
HCD/HCF1010RMS, HCD/HCF1410RMS,
HCD1010NMS, HCD1410NMS
(See model number configurator on page 2 for details.)
Order parts online
www.follettice.com
(1) Horizon
Chewblet
®
(purchased separately)
Horizon Elite
Ice Machine Models with RIDE
™
Installation Instructions for Ice Manager
™
Ice Machine
801 Church Lane • Easton, PA 18040, USA
Toll free (877) 612-5086 • +1 (610) 252-7301
www.follettice.com
Ice Manager
Control Panel
Ice Manager
Diverter Valve
(2) ice storage units
(purchased separately)
Any combination of bins or dispensers
Technology
®
Diverter Valve
™
remote condensing
01113372R00
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Follett Horizon Elite HCF1010RMS
Summary of Contents for Follett Horizon Elite HCF1010RMS
- Page 1 Horizon Elite Ice Machine Models with RIDE Technology ™ ® Installation Instructions for Ice Manager Diverter Valve ™ HCD/HCF1010RMS, HCD/HCF1410RMS, HCD1010NMS, HCD1410NMS (See model number configurator on page 2 for details.) Order parts online www.follettice.com remote condensing Ice Manager Control Panel Ice Manager Diverter Valve (1) Horizon...
- Page 2 Chewblet Ice Machine Model Number Configurations ® 1400 Application Configuration Icemaker Voltage Series Condenser MC Maestro™ C 208-230/60/1 (icemaking head) 400 up to A Air-cooled, self-contained V Vision™ S RIDE™ Self-contained only. 454 lbs Chewblet W Water-cooled, self-contained H Harmony™ (RIDE remote ®...
- Page 3 Horizon ice machine for use with Ice Manager diverter valve system The Ice Manager diverter valve system delivers ice to two ice storage units enabling a single Follett Horizon ice machine to meet demand for ice at two locations. The system’s sensors monitor ice levels in each storage unit and automatically switch ice delivery to the appropriate location.
- Page 4 Unpack Carefully unpack and inspect the contents of your Follett ice machine. Unpack ice machine ➊ ➋ ➌ ➍ 7/16" 7/16" ➎ ➏ ICE MANAGER remote condensing...
-
Page 5: Site Preparation
• 10-70 psi (69-483kpa) • 45-90 F (7-32 C) • Follett recommends the use of an in-line water filtration system (item# 00130286) • This equipment is to be installed with adequate backflow protection to comply with applicable federal, state, and local codes Drain ➌... - Page 6 Louvered docking assembly Install the louvered docking assembly. Wall bracket accessory Machine stand accessory • Mount louvered docking assembly to wall • Mount louvered docking assembly to bracket accessory machine stand accessory Louvered docking assembly 2" (50,8 mm) 1.88" (47,8 mm) ➋...
- Page 7 Undercounter installation requirements Top View ➌ ➊ 3.25" (83 mm) min. Access panel/ door on counter 22.25" min. (656 mm) 24" min. (609 mm No Lip ➋ DOCKING STATION • Position and screw louvered docking assembly to the bottom of counter inside of access panel/ ➊...
-
Page 8: Ice Transport Tube
Ice transport tube Install the ice transport tube. Ice transport tube installation. ➍ ➋ Hot Water 160 F (71 C) ➏ ➎ ➐ ➊ 1/4" ➌ Ice transport tube tips ➊ • Insulate entire length of ice transport tube ➋ •... -
Page 9: External Connections
External connections Connect utilities to louvered docking assembly. CAUTION • Plug must be accessible after final installation. Water and drain Refrigerant ➋ ➊ ➌ ➊ • Remove access panel if necessary. • Braze supplied expandable refrigerant ➊ lines in place •... -
Page 10: Internal Connections
Internal connections Connect louvered docking assembly to ice machine. Ice transport tube installation Water line ➋ ➊ ➋ ➊ • Slide ice machine into louvered docking • Insert potable water line into valve ➊ assembly ensuring that drain tube is fully seated on barbed drain fitting ➊... - Page 11 TDS switch Power cord HIGH CLEAN • Set the TDS switch on the electrical box: • Position plate into opening and secure with supplied screw HIGH: for extended service life LOW: for low-scale water ICE MANAGER remote condensing...
-
Page 12: Front Cover
Front cover Install front cover to ice machine. Install condensing unit Install ice machine front cover ➋ ➊ • Slide ice machine cover over machine ensuring that tabs on back of cover slip under louvers on back of louvered • Complete installation of condensing unit docking assembly ➊... - Page 13 Long tube run recommendations max. 2 ft (.6m) 1/4" • Pitch ice transport tube to allow melt water to drain towards ice machine ➊ • Secure insulated ice transport tube at least every 2 ft (.6m) to prevent dips or traps ➋...
- Page 14 ICE MANAGER remote condensing...
- Page 15 ICE MANAGER remote condensing...
- Page 16 Horizon, Horizon Elite, Maestro, Harmony, Ice Manager, SafeCLEAN, Sani-Sponge and Vision are trademarks of Follett Corporation. Chewblet, RIDE and Follett are registered trademarks of Follett Corporation, registered in the US. 801 Church Lane • Easton, PA 18040, USA 01113372R00 Toll free (877) 612-5086 • +1 (610) 252-7301 www.follettice.com...
Need help?
Do you have a question about the Horizon Elite HCF1010RMS and is the answer not in the manual?
Questions and answers