Getting Started With Ao Applications In Software - National Instruments PXI-6238 User Manual

Chapter 5 Analog Output
ao/SampleClockTimebase is not available as an output on the I/O
connector.
You might use ao/SampleClockTimebase if you want to use an external
sample clock signal, but need to divide the signal down. If you want to use
an external sample clock signal but do not need to divide the signal, then
you should use ao/SampleClock rather than ao/SampleClockTimebase.

Getting Started with AO Applications in Software

You can use an M Series device in the following analog output applications.
•
•
•
•
You can perform these generations through programmed I/O, interrupt, or
DMA data transfer mechanisms. Some of the applications also use start
triggers and pause triggers.
Note For more information about programming analog output applications and triggers in
software, refer to the NI-DAQmx Help or the LabVIEW 8.x Help.
NI 6238/6239 User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Single-point (on-demand) generation
Finite generation
Continuous generation
Waveform generation
5-10 ni.com