Chapter 3
Analog Output
Figure 3-10 shows the timing requirements for MasterTimebase.
Figure 3-10. MasterTimebase Timing Requirements
Getting Started with AO Applications in Software
You can use the AO Series device in the following analog output applications.
•
Single-Point Generation
•
Finite Generation
•
Continuous Generation
•
Waveform Generation
You can perform these generations through programmed I/O, interrupt, or DMA data transfer
mechanisms. Some of the applications also use start triggers and pause triggers.
For more information about programming analog output applications and
Note
triggers in software, refer to the NI-DAQmx Help.
3-10 | ni.com
t
p
t
t
w
w
t
= 50 ns minimum
p
t
= 23 ns minimum
w