Using Rtsi As Outputs - National Instruments PXI-6238 User Manual

Using RTSI as Outputs

RTSI <0..7> are bidirectional terminals. As an output, you can drive any of
the following signals to any RTSI terminal.
•
•
•
•
•
•
•
•
•
•
•
•
Note Signals with a * are inverted before being driven on the RTSI terminals.
© National Instruments Corporation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 10-1. RTSI Signal Descriptions
RTSI Bus Signal
RTSI 7
RTSI 6
RTSI 5
RTSI 4
RTSI 3
RTSI 2
RTSI 1
RTSI 0
Not Connected. Do not connect signals
to these terminals.
GND
Note: RTSI <0..7> and GND are earth/chassis ground-referenced. They are not isolated.
ai/StartTrigger
ai/ReferenceTrigger
ai/ConvertClock*
ai/SampleClock
ai/PauseTrigger
ao/SampleClock*
ao/StartTrigger
ao/PauseTrigger
10 MHz Reference Clock
Counter n Source, Gate, Z, Internal Output
FREQ OUT
Input PFI <0..5>
10-5
Chapter 10 Digital Routing and Clock Generation
Terminal
34
32
30
28
26
24
22
20
1–18
19, 21, 23, 25, 27, 29, 31, 33
NI 6238/6239 User Manual