I/O Protection - National Instruments PXI-6238 User Manual

The filter setting for each input can be configured independently. On power
up, the filters are disabled. Figure 8-4 shows an example of a low-to-high
transition on an input that has its filter set to 125 ns (N = 5).
RTSI, PFI, or
PXI_STAR Terminal
1
Filter Clock
(40 MHz)
Filtered Input
Enabling filters introduces jitter on the input signal. For the 125 ns and
6.425 µs filter settings, the jitter is up to 25 ns. On the 2.55 ms setting, the
jitter is up to 10.025 µs.
When a PFI input is routed directly to RTSI, or a RTSI input is routed
directly to PFI, the M Series device does not use the filtered version of the
input signal.
Refer to the KnowledgeBase document, Digital Filtering with M Series
and CompactDAQ, for more information about digital filters and counters.
To access this KnowledgeBase, go to
code

I/O Protection

Each DI, DO, and PFI signal is protected against overvoltage and
undervoltage conditions as well as ESD events on NI 6238/6239 devices.
© National Instruments Corporation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 8-1. Filters
N (Filter
Clocks Needed
Filter Setting to Pass Signal)
125 ns 5
6.425 µs 257
2.55 ms ~101,800
Disabled —
1 2 3 4 1 2
Figure 8-4. Filter Example
.
rddfms
8-5
Chapter 8
Pulse Width Pulse Width
Guaranteed to Guaranteed to
Pass Filter Not Pass Filter
125 ns 100 ns
6.425 µs 6.400 µs
2.55 ms 2.54 ms
—
Filtered input goes high
when terminal is sampled
3 4 5
high on five consecutive
filter clocks.
and enter the info
ni.com/info
NI 6238/6239 User Manual
PFI
—