Honeywell Xtralis FAAST FLEX FLX-010 Product Manual page 31

FAAST FLEX Product Guide
6.3.2 Changing the Passcode
Example - Changing Passcode from 000000 to 123456
To change the passcode you must first enter the current passcode. Then you must enter the new passcode,
and then re-enter the new passcode a second time to confirm that it is correct. The following procedure
demonstrates changing the passcode from 000000 to 123456.
1. Long-press the TEST button to enter the CHANGE PASSCODE mode. LEDs 1, 2, 3 and 4 will flash
yellow, and then LED 1 will slow blink yellow indicating that the device is waiting for entry of the first
digit.
Note: The digit counter starts at 0, so pressing the ENTER button will record 0 as the current digit. The
following table summarizes the actions of button presses during the procedure.
2. Press the ENTER button six times to enter the default passcode (000000). Each time you press the
ENTER button, the LED corresponding to that digit will show steady yellow indicating the digit has been
entered. Once the sixth digit is entered, all six LEDs will show steady yellow.
3. Press the ENTER button again to confirm the passcode entry. The LEDs will all show green for five
seconds, then will go out.
4. LED 1 will show steady yellow, prompting you for the first digit of the new passcode. Enter the new
passcode as follows:
a. Press the SILENCE/+ button one time to enter 1 as the first digit. LED 1 will flash green as you
press the SILENCE/+ button.
b. Press the ENTER button to enter the first digit. LED 1 will show steady yellow.
c. Press the SILENCE/+ button twice to enter 2 as the second digit. LED 2 will flash green as you
press the SILENCE/+ button.
d. Press the ENTER button to enter the second digit. LED 1 and LED 2 will show steady yellow.
e. Press the SILENCE/+ button three times to enter 3 as the third digit. LED 3 will flash green as you
press the SILENCE/+ button.
f. Press the ENTER button to enter the third digit. LEDs 1, 2, and 3 will show steady yellow.
g. Press the SILENCE/+ button four times to enter 4 as the fourth digit. LED 4 will flash green as you
press the SILENCE/+ button.
h. Press the ENTER button to enter the fourth digit. LEDs 1, 2, 3 and 4 will show steady yellow.
i. Press the SILENCE/+ button five times to enter 5 as the fifth digit. LED 5 will flash green as you
press the SILENCE/+ button.
j. Press the ENTER button to enter the fifth digit. LEDs 1, 2, 3, 4, and 5 will show steady yellow.
k. Press the SILENCE/+ button six times to enter 6 as the last digit. LED 6 will flash green as you
press the SILENCE/+ button.
l. Press the ENTER button to enter the last digit. All LEDs will show green for 5 seconds, and then
will go out.
5. Repeat the procedure in step 4 to re-enter and confirm the new passcode.
Note: After three failed attempts to enter the passcode, the unit will return to WAIT mode. The user must
wait 20 seconds before attempting to re-enter the passcode. Each subsequent attempt will
increase the wait time by an additional 20 seconds.
24
FAAST FLEX
www.xtralis.com