Orientation; Front Label - Honeywell Xtralis FAAST FLEX FLX-010 Product Manual

FAAST FLEX Product Guide
3.4

Orientation

The FAAST FLEX can be mounted either in standard orientation or inverted (see Figure 3-5). The access and
location of the inlet and outlet pipes is usually the determining factor in selecting the orientation.
Note: Inverted installation must be set using dip-switch 9.
STANDARD MOUNTING
DIP SWITCH
SETTING
9 10
3.5

Front Label

The device is shipped with the front panel labels installed for standard mounting. The labels are double-sided;
one side is printed for standard mounting, and the reverse side is printed for inverted mounting (see
Figure 3-6). The label should be installed to match the mounting orientation. To place the label, detach the 4
gray clips from inside the cover and snap the retainers off the device. Position the label as desired, then snap
the retainer back in place.
Note: Inverted installation must be set using dip-switch 9.
11
AIR INLETS
AIR OUTLET
Figure 3-5: Mounting Orientation
Figure 3-6: Front Label Installation
INVERTED MOUNTING
AIR OUTLET
AIR INLETS
FAAST FLEX
DIP SWITCH
SETTING
9 10
www.xtralis.com