To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
Make sure the projector is turned on.
Press MENU/EXIT on the projector or Menu on the remote control and then press
until the NetWork menu is highlighted.
Highlight Wireless LAN and press ENTER on the projector or Enter on the
Make sure the Status is Connect.
Make sure the SSID information is displayed.
to highlight Connection Mode and press
Infrastructure. In AP mode, you need to use your computer's wireless
connection utility to search the projector's SSID and connect to it. Then you can
search the projector with pwPresenter. To use Infrastructure mode, you should
connect both your computer and projector to the same AP router and make
connections with the IP address.
If you need more information about AP and Infrastructure modes, please
refer to user documentations for Wireless Routers which are usually
available on 3C stores.
to select AP or