Wireless Connection - ViewSonic Pro8600 User Manual

Wireless connection

ViewSonic wireless dongle
To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
1. Make sure the projector is turned on.
2. Press MENU/EXIT on the projector or Menu on the remote control and then press
/ until the Network menu is highlighted.
3. Highlight Wireless LAN and press ENTER on the projector or Enter on the remote
control.
4. Make sure the Status is Connect.
5. Make sure the SSID information is displayed.
6. In AP mode, you need to use your computer's wireless connection utility to search
the projector's SSID and connect to it. Then you can search the projector with
vsPresenter. To use Infrastructure mode, you should connect both your computer
and projector to the same AP router and make connections with the IP address.
About AP and Infrastructure modes
In AP mode, you need to use your computer's wireless connection utility to search for the
projector's SSID and connect to it. Then you can search for the projector with vsPresenter.
In Infrastructure mode, you should connect both your computer and projector to the same
AP router and make connections with the IP address.
The following diagram describes how to access the Internet in AP and Infrastructure
modes.
(AP Mode)
Important
•
If you need more information about AP and Infrastructure modes, please refer to user
documentations for Wireless Routers which are usually available on 3C stores.
(Infrastructure Mode)
Internet
34
Internet