Advertisement
FIT AND SECURE
2
2.4
2.5
2.6
Ladder Side
LAMG003_REV_A00
5
17
15
3
4
3
9
70mm
Door Frame Edge
Loosly assemble the Ladder Top Assembly
(Item 1) to the Ladder sides (Item 2) using
1
M6 x 16 Flange Button Heads and M6 Nyloc
Nuts (Items 5 & 17).
Torx
T30
10mm
Torx
T30
Secure the Steps (Item 3 & 9) to the Ladder
Sides as shown using M6 x 25 Thread
Forming Screws (Item 4)
Swing open the Gutter Clamp on the top
assembly. Fit the top assembly into vehicle's
gutter and let the Bottom Support rest
against the vehicle. Align and space the
Ladder Side at the top and the Ladder Side
at the bottom, 70mm away from door frame
edge.
Fully tighten the two M6 x 60 Cap Screws,
5mm
clamping the Ladder to the gutter.
Clean the surface area where the Double
Sided Tape rests against the vehicle with
Denatured Alcohol.
Denatured
Make sure the spacing at the top and bottom
Alcohol
is 70mm from the Door Frame Edge.
Remove the backing tape from the Double
Sided Tape and firmly push and secure the
bottom of the ladder against the vehicle.
4
Use a little petroleum jelly on screw
threads before inserting. Note these are
Thread Forming Screws.
NOTE: Step Length differs refer to fig 1.1
or 2.5.
Tightening Torque:
M6 : 8-10Nm / 5.9 ft lb - 7.38 ft lb
© 2022 FRONT RUNNER VEHICLE OUTFITTERS
Advertisement
