BLOTZ B06-CS-009 Quick Start Manual

6mm control tower

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Remove the pieces shown above from the sprue.

Glue the top into place.

Glue them into place around the model.

Glue the long sections to the larger base (see

pic), attaching them to the inner support at the

same time. Note four of the long sections have

longer lugs at one end. These should alternate.

6mm Control Tower

B06-CS-009

Glue the walls to the base as shown above.

Take the four outer walls.

Take the pieces shown above.

Take the end cap...

Table of Contents

Need help?

Do you have a question about the B06-CS-009 and is the answer not in the manual?

Page 1 6mm Control Tower B06-CS-009 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 And glue it into position (see above) Turn the tower assembly over and glue it to the base assembly. Take four of the upper supports from the sprue. Glue thesew around the head as shown. Add the cap piece. Then add the other four supports. Insert their top lug first, then slide them into position.