BLOTZ B00-ACC-400 Assembly Instructions

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
Take one long edge piece and two of the shorter sides from the sprue.
Glue the short sections into the notches cut in the long piece, then add the second long side.
Glue the other two short pieces into position to form the other two sides of the insert.
Once the glue is dry, you can place the insert into your box and add the dividers.

Box Insert #1

B00-ACC-400
Please read these instructions fully before starting construction.
(see pic above)