BLOTZ B06-CS-006 Quick Start Manual

BLOTZ B06-CS-006 Quick Start Manual

6mm car park

Advertisement

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base floor and four walls (as shown above)
from the sprue.
Remove each set of "leg" pieces (pair on the left) from
the sprue and glue them together to form the piece on
Each end of the supper storey is formed from the
pieces shown.
Then add the small wall and ramp.
6mm Car park
B06-CS-006
Please read these instructions fully before starting construction.
the right.
Glue the walls to the base as shown, using the
lugs/holes provided to align the sections.
Glue the legs to the underside of the upper storey's
floor (as shown).
Glue the inner piece into place.
Then the outer wall.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B06-CS-006 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ B06-CS-006

  • Page 1 6mm Car park B06-CS-006 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 2 Glue the two long side walls into place. Stack the pieces to form the finished Car Park.

Table of Contents