BLOTZ B06-MW-100 Assembly Instructions

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.

Foyer (B06-MW-100)

Start by removing the short sides from the sprue
along with the two bracers.
Attach the long sides, so that both the side lugs
and bracer lugs fit into the holes provided.
Attach the columns and balconies to the long
sides as shown above.
6mm 3x2 Shops Foyer
B06-MW-100
Please read these instructions fully before starting construction.
Glue the bracers bar to the back of the short side,
positioned using the lugs provided.
This will give you a hollow box shape.
Then attach the columns and balconies to the short
sides.