BLOTZ B06-CS-100 Manual

6mm 3x3 tower block foyer

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Foyer (B06-CS-100)

Remove the front piece and its rear support from

the sprue.

Now remove the rear wall and its rear support

from the sprue.

Take the two side walls and glue them to the

front piece (with the doors towards the front of

the model). Then attach the rear wall. Allow the

model to dry.

6mm 3x3 Tower Block Foyer

B06-CS-100

Please read these instructions fully before starting construction.

Glue the support to the back of the piece using the

holes / lugs provided.

Glue the support to the back of the piece using the

holes/lugs provided.

Take the entrance piece from the sprue.

Table of Contents

Do you have a question about the B06-CS-100 and is the answer not in the manual?

Page 1 During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while you allow glue to dry. Foyer (B06-CS-100) Glue the support to the back of the piece using the holes / lugs provided.
Page 2 Flip the model upside down and insert the Finally remove the eight decorative strips from the entrance way piece. The four lugs on it should sprue and attach them to the building using the slot into the holes provided. lugs/holes provided.
Page 3 6mm 3x3 Tower Block Middle B06-CS-150 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 4 6mm 3x3 Tower Block Roof B06-MW-200 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.