2.4 Powering Device On; 2.5 Shutting Device Down; 2.6 Waking Device Up; 3. Setup - Concox QBIT M User Manual

2.4 Powering Device On

If the device is in shutdown state, press and hold the Power
button for 3 seconds, the LED will turn white and the buzzer
will beep twice to indicate that the device has been
successfully powered on.
After that, the device LED flashes blue to indicate it is
working correctly (refer to LED Indication for details).

2.5 Shutting Device Down

If the device is in power-on state, press and hold the Power
button for 3 seconds, the LED will turn white and the buzzer
will beep once to indicate that the device has been
successfully shut down.
Note: If an error prompt appears during shutdown, please
check if the device has been configured with a shutdown
restriction.

2.6 Waking Device Up

If the device is in sleep mode, press the panic button for 4
times in 5 seconds to wake the device up. Upon wakeup,
the device LED will turn blue for 1 second and then work
as preset.
Note: If the device has been configured with a
wakeup prompt tone, the buzzer will beep.

3. Setup

3.1 Working Mode

The device can work in 3 modes - regular GPS, intelligent,
and tracking, allowing you to switch based on specific needs.