J.P. SELECTA AUTESTER ST DRY PV-B print 18L Manual page 36

INSTRUCTION MANUAL
4.1 Autoclaves type «B»
Autester ST DRY PV autoclaves allow sterilization of:
• Solid loads resistant to temperature: instrumental, metallic.
• Solid loads sensitive to temperature: plastics
• Solid packed load.
• Porous load: textiles
• Wrapped porous load.
• Catheters, tubes and cavities devices.
• Liquids.
4.2 Technical specifications
Model
Supply voltage:
Power:
Fuse:
Working temperature:
Noise:
Maximum weight per tray:
Maximum heat radiation (from 20 to 26ºC): < 2000J
Chamber material:
Maximum working pressure:
Minimum working pressure:
Maximum temperature:
Chamber diameter measurements:
Water volume per cycle:
Water tank volume:
4.3 Sterilization cycle
1-2 pre-heating
2-3 pre-vacuum
3-4 sterilizing
4-5 air-discharging
5-6 drying
6-7 stabilizing
1-7 entire duration
Sterilization cycles types
Type B: The sterilization of all wrapped or non-wrapped, solid, hollow load products type A and porous pro-
ducts as represented by the test loads in this standard.
Type S: The sterilization of products as specified by the manufacturer of the sterilizer including non-wrapped
solid products and at least one of the following: porous products, small porous items, hollow load
products type A, hollow load products B, single wrapped products, multiple-layer wrapped products.
NOTE 1 The description identifies ranges of products and test loads.
NOTE 2 Non wrapped sterilized instruments are intended either for immediate use or for non sterile
storage, transport and application (e.g. to prevent cross infection).
J
.P. SELECTA s.a.u.
CODE 80416 REV D
4001738
220V, 50Hz
1500VA
F12AL
5-40ºC
< 50dBA
1 Kg
Stainless steel
2.5bar
-0.9bar
145ºC
245x360mm
0.16L
3.5L
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
12/2023
4001739
220V, 50Hz
1700VA
F12AL
5-40ºC
< 50dBA
1 Kg
< 2000J
Stainless steel
2.5bar
-0.9bar
145ºC
245x470mm
0.18L
4L
Tel 34 937 700 877 Fax 34 937 702 362
Page: 36