Air Flow Selection And Adjustment - Friedrich ZoneAire Premier PDE07K3SGR3 Installation And Operation Manual

J. STARTUP AND OPERATION
J.2 Air Flow Selection and Adjustment
VENTILATION CONTROL
The ventilation control lever is located at left
side of unit, behind front panel.
NOTE:The vent door shipping hardware must be
removed before using vent control lever. See
Installation Instructions.
When set at close POSITION, only the air inside
the room is circulated and filtered.
When set at open POSITION, some outdoor air
will be drawn into room. This will reduce heating
or cooling efficiency.
EnergyTip : Keep the vent control at closed
POSITION. Room air will be filtered and
circulated.
ADJUSTING AIR DIRECTION
To adjust air direction:
1. Remove front panel.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 301
3. Turn louver insert and rotate 180 See Fig.302
4. Replace louver insert.
5. Replace screws and front panel.
Figure 302 (Backside of Front Panel)
Air discharge upward
28
Open position
Vent Control
(Pull lever through label
to operate.)
Louver screws
Figure 303 (Adjusting Louvers)
Close position
Figure 301 (Ventilation Control Location)
Air discharge outward (Default)