Table of Contents
Advertisement
C.4.4 Standard Grille Instructions
1.
Remove the center support and weatherboard if still installed
in the sleeve.
2.
Insert six plastic grommets into the grille openings from the
outside of the grille as shown in Figure C.4.4.
3/8"
3.
Insert two #8 x
sheet metal screws (provided) in the top
two outside edge plastic grommets, and tighten them half way
into the grommets.
4.
Grasp the grille by the attached plastic handles. Position
it with the condensate drain knockouts facing down.
From inside the building, maneuver the grille through the wall
sleeve and pull toward you until the screw heads are inserted
into the keyhole slots at the top of the wall sleeve. Tighten the
two screws completely.
5.
Insert the remaining screws into the remaining holes and tighten
securely.
C. INSTALLATION OF THE UNIT
Figure C.4.4 Standard Grille Instructions
WARNING
Falling Object Hazard
Not following Installation Instructions for
mounting your air conditioner can result
in property damage, injury, or death.
19
Advertisement
Table of Contents
