Operation; Airflow Selection And Adjustment - Friedrich KCS08A10A Service Manual

OPERATION

Airflow Selection and Adjustment

The airflow path may be adjusted to distribute air independently from the left or right side of the discharge opening. Each of the
banks of louvers can be directed left, right, up, or down in order to achieve the most optimum airflow positioning.
To adjust airflow direction, grab the lever in the center of the louver bank and move it in the direction that you would like the air
to be directed. Please note that it is normal that airflow may be stronger out of one side of the louvers than the other.
Fresh air and exhaust control
Your air conditioner has the ability to bring fresh air into the room or exhaust stale air out of the room. The control slide is found on
the upper part of the unit (see Figure 301).
TO BRING IN FRESH AIR – Move the lever to the Fresh Air
position which allows outside air to enter the room. This is useful
in fall and spring as a means of bringing in fresh outside air when using FAN ONLY. It can also be used in the summer with the
compressor in the Cooling Mode if you wish.
TO EXHAUST INDOOR AIR – Move the lever to the Exhaust position. This will allow stale air to be expelled to the outside of
the dwelling. This is especially handy in the spring or fall when indoor air tends to get stale, or after a social gathering involving
smokers, or to remove cooking odors.
BEST PERFORMANCE – Move the lever to the Re-Circulate Position.
This is the most efficient mode for cooling and heating. In this
mode the unit will not bring air in or exhaust air.
Air Lever
Figure 301 (AIRFLOW SELECTION AND ADJUSTMENT)
15