Standard Filter Removal / Installation Instructions - Friedrich Q Series Service & Parts Manual

ROUTINE MAINTENANCE

Standard Filter Removal / Installation Instructions

1.
Swing the door open, See Figure 402,and remove the filter by grasping the filter grip and pushing the filter holder upward and outward. See Figure
403.
2.
Slide the filter grip out from the filter as shown in Figure 404.
NOTE:
Make sure the front frame with the mesh filter is facing you.
3.
Swing the front frame open. See Figure 405. Clean the front frame by washing the dirt from the filter. Use a mild soap solution if necessary. Allow
filter to dry.
4.
Install the filter grip back into the filter by sliding it into the filter.
NOTE:
The filter handle slides into the frame in only one direction. If the tab in the frame stops the handle from sliding in, slide the handle from the other
direction. DO NOT FORCE THE HANDLE INTO THE FRAME.
39
Figure 402
Figure 403
FILTER GRIP
FRR052
HANDLE
Figure 404
Figure 405
A
FRONT
FRAME WITH
STANDARD
MESH FILTER
FILTER
FILTER GRIP
TOP TAB