Yale Z-Wave Plus ™ Product Info; Network Operations; Enroll/Add Device To Network (Smartstart) - Yale Assure Lock 2 Installation Instructions Manual

Yale Z-Wave Plus ™ Product Info
Manufacturer ID: ASSA ABLOY (0x0129)
Z-Wave ™ Device Type: Door Lock Keypad
Z-Wave ™ Role Type: Listening Sleeping Slave (LSS)

Network Operations

Enroll/Add device to network (SmartStart)

SmartStart enabled products can be added into a Z-Wave
Z-Wave™ QR Code present on the product with a controller providing SmartStart
inclusion. No further action is required and the SmartStart product will be added
automatically within 10 minutes of being switched on in the network vicinity.
• Open the Z-Wave
follow the in-app prompts to add a new device.
• SmartStart works when the Z-Wave
the following are true:
o The lock has the minimum Radio Module firmware version AND is in a
factory-reset state:
AYR-MOD-ZW3-USA: v2.40
▪
o The lock has the minimum Lock firmware version AND is in a factory-
reset state:
YRD410/420/430/450: v1.3.14
▪
YRD614/624/634/654: v1.3.14
▪
o An internal key has already been established.
™ system's smart home app via smartphone or tablet and
• NOTE: If AYR-MOD-ZW3-USA @ FW v2.39 is inserted in
lock
o Known Issue
The Configuration Set Command wrapped in
Supervision Command Class will report a failure
status in the Supervision Report even though the
parameter's value was updated.
Steps to Avoid
Option 1: The Configuration Report Command must
be used to validate the success of the Configuration
Set Command and the parameter's value change.
Option 2: Use the Configuration Set Command not
wrapped in Supervision Command Class.
5
™ network by scanning the
™ system has the DSK saved and one of