Installing The Z-Wave Plus Module; Enrolling/Unenrolling The Network Module - Yale YRD216 Installation And Programming Instructions

Installing the Z -Wave
IMPORTANT: the batteries
to removing and/or inserting the network module:
• Remove battery cover and batteries.
• Remove and/or insert Network Module.
• Reinstall batteries and battery cover.

Enrolling/Unenrolling the Network Module:

This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave
Plus messages to communicate to other security enabled Z-Wave Plus products. This device
must be used in conjunction with a Security Enabled Z-Wave Controller in order to fully utilize
all implemented functions. This product can be operated in any Z-Wave network with other
Z-Wave certified devices from other manufacturers. All non-battery operated nodes within
the network will act as repeaters regardless of vendor to increase reliability of the network.
To Enroll/Add the Module (Inclusion Mode):
• Enter the 4-8 digit Master
• Press the key followed by the
• Press the key followed by the
To Unenroll/Remove the Module (Exclusion Mode):
• Enter the 4-8 digit Master
• Press the key followed by the
• Press the key followed by the
Factory Reset - If No Controller:
• See the Lock Installation Manual
• Please use this procedure only when the network primary controller is missing or
otherwise inoperable.
For specific Z-Wave Plus association and parameter information for your lock, please visit
YaleResidential.com/ZwavePlus
®
Installation and Programming Instructions
Plus Module
®
must be removed prior
PIN code followed by the
key.
key.
PIN code followed by the
key.
key.
Yale Z -Wave Plus Module
® ®
key.
key.
P/N AYR 202- ZW INSTAL FUL - - Rev C