Samson 3730-2 Mounting And Operating Instructions page 50

Start-up and settings
known, it is recommended to accept its K
and T values.
V
After setting the AIR TO OPEN/CLOSE
switch for the fail-safe position, setting the
volume restriction and pressing the INIT key,
the positioner calculates its configuration
data on the basis of the blocking position
and the closing direction as well as the other
entered data.
The positioner switches to manual operation,
subsequently the blocking position should be
canceled as described on page 52.
Enable configuration:
Turn → Code , press
turn → ON , press
After enabling:
mm
Turn → Code 4 , press
press → Select pin position entered dur-
ing installation, press
50
EB 8384-2 EN
Default OFF
,
.
Default OFF
,
.
P
Turn → Code 5 , press
turn → Enter nominal travel/angle,
press .
Turn → Code 6 , press
turn → Sub , press
Turn → Code 7 , press
turn → Retain direction of action ää or
select äæ.
Press .
Turn → Code 11 , press
turn → Deactivate travel limit,
press .
Default 15
mm
,
Default MAX
,
.
Default ää
,
Default 100.0
,