Network - Avigilon H4VI-RO1-IR Interface User Manual

Set up NTP on the DHCP server used by the ACC software.
l
Use a valid public NTP server.
l
Manually set the correct time in the Time Settings fields.
l
6. Click Apply to save your settings.

Network

On the Network page, you can change how the camera connects to the server network and choose how the
camera keeps time.
1. At the top of the page, select how the camera obtains an IP address:
Obtain an IP address automatically: select this option to connect to the network through an
l
automatically assigned IP address.
The IP address is obtained from a DHCP server. If it cannot obtain an address, the IP address
will default to addresses in the 169.254.x.x range.
Use the following IP address: select this option to manually assign a static IP address.
l
o
IP Address: Enter the IP Address you want to use.
o
Subnet Mask: Enter the Subnet Mask you want to use.
o
Default Gateway: Enter the Default Gateway you want to use.
2. Select the Disable setting static IP address through ARP/Ping method check box to disable the
ARP/Ping method of setting an IP address.
3. If the camera supports IPv6, select the Enable IPv6 check box to configure the following settings.
Note: Enabling IPv6 does not disable IPv4 settings.
a. Select the Accept Router Advertisements check box if using Stateless Address Auto-
Configuration.
b. From the DHCPv6 State drop-down list, select one of the following:
Auto: DHCPv6 state is determined by router advertisements (RA).
l
Stateful: the camera receives IP address, DNS and NTP information from the DHCPv6
l
server.
Stateless: the camera only receives DNS and NTP information from the DHCPv6 server.
l
It does not accept an IP address from the DHCPv6 server.
Off: the camera does not communicate with the DHCPv6 server.
l
Network
Note: The Accept Router Advertisements setting must be enabled for this
setting to perform as expected.
7